Ford Escape: Replacing headlamp bulbs
1. Make sure the headlamp control is in the off position.
2. Open the hood.
3. Reach over the front bolster.
4. Remove the bulb by turning it
counterclockwise and then pulling it
straight out.
5. Disconnect the electrical connector from the bulb.
WARNING: Handle a halogen headlamp bulb carefully and keep out of children’s reach. Grasp the bulb only by its plastic base and do not touch the glass. The oil from your hand could cause the bulb to break the next time the headlamps are operated.
6. Connect the electrical connector on the new bulb.
7. Insert the glass end of the new bulb into the headlamp assembly.
When the grooves in the plastic base are aligned, turn the new bulb clockwise to install.
- Replacing front parking lamp/turn signal bulbs
- Replacing front sidemarker bulbs
- Replacing tail/stop/turn/backup lamp bulbs
- Replacing high-mount brake lamp bulbs
- Replacing license plate lamp bulbs
- Replacing fog lamp bulbs (if equipped)
Using the right bulbs
Replacement bulbs are specified in the chart below. Headlamp bulbs must be marked with an authorized “D.O.T.” for North America and an “E” for Europe to ensure lamp performance, light bright ...Replacing front parking lamp/turn signal bulbs
1. Make sure the headlamp control is in the off position. 2. Open the hood. 3. Reach over the front bolster. 4. Rotate the bulb socket counterclockwise and remove from the lamp assembly. 5. Ca ...See also:
Sway control device
Sudden maneuvers, wind gusts and buffeting
caused by other vehicles can affect trailer
handling. Sway control devices may be used to
help control these affects. If you choose to use
one, conta ...
Jump-starting procedures
If your vehicle has a discharged battery it can be jumpstarted
using a set of jumper cables and a battery in
another vehicle or by using a portable battery booster
pack. Jump-starting can be dan ...
MMT
Some gasoline contains an octane-enhancing
additive called MMT (Methylcyclopentadienyl
Manganese Tricarbonyl). If
you use such fuels, your emission control
system performance may deteriorate a ...