Volvo XC60: Reinserting the headlight housing - Headlight housing - Replacing bulbs - Maintenance and specifications - Volvo XC60 Owner's ManualVolvo XC60: Reinserting the headlight housing

When reinserting the housing, be sure that the

When reinserting the housing, be sure that the long locking pin (to the left in the illustration) is securely in place in both of its retaining clamps.

1. Plug in the connector until it clicks into place.

2. Reinstall the headlight housing and locking pins. Check that they are correctly inserted. The headlight housing must be properly inserted and secured in place before the lighting is switched on or the remote key is inserted into the ignition slot.

3. Check that the lights function properly.

The headlight wiring must be connected and the housing must be securely in place before the ignition is switched on.

    Removing the headlight housing
    1. Switch off the ignition by briefly pressing the START/STOP ENGINE button. 2. Remove the remote key from the ignition slot1. 3. (Upper illustration under "Headlight housing"). &nb ...

    Removing the cover to access the bulbs
    NOTE Before starting to replace a bulb, see page 322. 1. Open the retaining clamps by pressing them to the sides. 2. Pull the cover straight out. Reinstall the cover in the reverse order. ...

    See also:

    Facts about TSA
    • TSA intervenes at speeds above approximately 40 mph (60 km/h) • The DSTC symbol () in the instrument panel will flash when TSA is working • If the driver switches off the DSTC system's ...

    Front seats
    Front seats 1 Lumbar support: turn the control for firmer or softer lumbar support. 2 Front-rear adjustment: lift the bar and move the seat to the position of your choice. 3 Raise/lower fro ...

    Transfer Case Position Indicator Lights
    The four-wheel drive indicator lights (4WD, 4 LOW) are located in the instrument cluster. The NEUTRAL indicator light is located on the transfer case switch. If there is no indicator light on or ...