Mercedes-Benz GLK-Class: Matte finish care - Exterior care - Care - Maintenance and care - Mercedes-Benz GLK-Class Owner's ManualMercedes-Benz GLK-Class: Matte finish care

If your vehicle has a clear matte finish, observe the following instructions in order to avoid damage to the paintwork due to incorrect care.

These notes also apply to light alloy wheels with a clear matte finish.

to shine. Never polish the vehicle or the light alloy wheels. Polishing causes the finish to shine.

effect: The following may cause the paint to become shiny and thus reduce the matte effect:

  • Vigorous rubbing with unsuitable materials.
  • Frequent use of car washes.
  • Washing the vehicle in direct sunlight.

e.g. wax. These products are only suitable for high-gloss surfaces. Their use on Never use paint cleaner, buffing or polishing products, or gloss preserver, e.g. wax. These products are only suitable for high-gloss surfaces. Their use on vehicles with matte finish leads to considerable surface damage (shiny, spotted areas).

Always have paintwork repairs performed at a qualified specialist workshop, e.g. an authorized Mercedes-Benz Center.

Do not use wash programs with a hot wax treatment under any circumstances.

and plenty of water. The vehicle should preferably be washed by hand using a soft sponge, car shampoo and plenty of water.

Mercedes-Benz care products. Use only insect remover and car shampoo from the range of recommended and approved Mercedes-Benz care products.

    Cleaning the paintwork
    Scratches, corrosive deposits, areas affected by corrosion and damage caused by inadequate care cannot always be completely repaired. In such cases, visit a qualified specialist workshop, e.g. an ...

    Cleaning the windows
    WARNING Before cleaning the windshield or wiper blades, switch off the windshield wipers and remove the SmartKey from the ignition lock. On vehicles with KEYLESS-GO, press the Start/Stop but ...

    See also:

    Attaching the towing eyelet
    1 The towing eyelet is located under the floor of the cargo area, with the spare tire and may be partially concealed. This eyelet must be screwed into the positions provided on the right sides ...

    Preparations For Jump-Start
    The battery in your vehicle is located in the front of the engine compartment, behind the left headlight assembly. NOTE: The positive battery post is covered with a protective cap. Lift up on the ...

    Draining Fluid
    First remove the fill plug (1), then the drain plug (2). Recommended tightening torque for the drain and fill plugs is 15–25 ft lbs (20–34 N·m). CAUTION! Do not over-tighten the plugs. You ...