Range Rover Evoque: Lighting control
Lighting control
1. With the headlamps on, push the control
away from the steering wheel to select high
beam. The instrument pack warning lamp
will illuminate.
Note: Do not use high beam where it may
distract other road users.
2. Pull the control towards the steering wheel
and release to flash the high beam on and
off. The high beam will remain on for as
long as the switch is held.
3. Sidelights.
4. Headlamps.
5. AUTO. With Auto lamps selected, when
ambient light fades and the ignition is on,
the side lamps, tail lamps, low beam
headlamps and licence plate lamps will
switch on automatically. Headlamp
courtesy delay, High beam assist and
Windscreen wipers detection may also be
activated.
Note: Low exterior light levels, caused by
adverse weather conditions, may also
cause the autolamp system to activate.
6. Rear fog lamps. Will operate only while
sidelights, headlamps or Auto lamps are
selected. Turn the collar towards the
steering wheel and release. The instrument
pack warning lamp will illuminate.
7. Front fog lamps. Will operate only while
sidelights, headlamps or Auto lamps are
selected. Turn the collar away from the
steering wheel and release.The instrument
pack warning lamp will illuminate.
READ NEXT:
Daytime running lamps are LED lamps.
With the lighting control in the OFF position or
in AUTO position while lighting conditions do
not require headlamps on, then daytime
running lamps will switch
This feature operates whenever the lamps
master switch is in the AUTO (5) position and
the ignition is turned off. The headlamps will
remain illuminated for up to 240 seconds.
Note: The time delay
This feature of the Xenon lighting automatically
selects and deselects high beam, under
specific conditions of road lighting and in the
absence of other vehicle’s lights. The system is
only acti
SEE MORE:
The engine will not automatically stop if:<>
- the external temperature is below approximately 0°C (32°F)
- the external temperature is above approximately40°C (104°F)
- engine has not reached operating temperature
- driver’s seat belt is not fastened
- driver’s door is not fully
Removal
NOTES:
The inner quarter panel and wheelhouse is manufactured from mild steel.
The aid of a second technician is required to remove, offer up and align the
inner quarter panel and wheelhouse.
The service panel is not fully welded.
1. In this procedure, to make sure the vehicle is correctl
© 2011-2024 Copyright www.rrevoque.org