Range Rover Evoque: Daytime running lamps

Daytime running lamps are LED lamps.

With the lighting control in the OFF position or in AUTO position while lighting conditions do not require headlamps on, then daytime running lamps will switch on automatically under the following conditions: - The engine is running.

- The gear selector is out of park (automatic transmission).

- The parking brake is not applied - market dependent.

Unless required or prohibited by law,

Unless required or prohibited by law, daytime running lamps can be disabled or enabled by your Dealer/Authorised Repairer.

READ NEXT:

 Headlamp courtesy delay

This feature operates whenever the lamps master switch is in the AUTO (5) position and the ignition is turned off. The headlamps will remain illuminated for up to 240 seconds. Note: The time delay

 High beam assist

This feature of the Xenon lighting automatically selects and deselects high beam, under specific conditions of road lighting and in the absence of other vehicle’s lights. The system is only acti

 Auto lamps windscreen wiper detection

If Auto lamps is selected and the windscreen wipers are switched on for 20 seconds or more, the side lamps, tail lamps and headlamps will switch on automatically. When the wipers are switched off,

SEE MORE:

 Engine Cooling - Diagnosis and Testing

Principles of Operation For a detailed description of the cooling system, refer to the relevant Description and Operation section in the workshop manual. REFER to: (303-03B Engine Cooling - GTDi 2.0L Petrol) Inspection and Verification CAUTION: Diagnosis by substitution from a donor vehicle is NOT

 Headlamp Assembly

Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. 3. 4. NOTE: Some components shown removed for clarity. 5. 6. 7. 8. 9. Remove all bumper lower fixing to assist the

© 2011-2024 Copyright www.rrevoque.org