Range Rover Evoque: Headlamps

Moving the nearside headlamp unit to access bulbs;

1. Remove the two plastic fixings.

1. Remove the two plastic fixings.

2. Pull the tube up to release from the air box.

This will allow more room for manoeuvrability.

3. Remove the four grille fixings.

4. Remove the two retaining bolts.

5. At the rear of the headlamp unit, pull up on the T grip release mechanism and hold while sliding the headlamp unit forward 40mm.

Moving the offside headlamp unit to access bulbs;

1. Remove the four grille fixings.

1. Remove the four grille fixings.

2. Remove the two retaining bolts.

3. Remove the fixing then move the filler tube rearwards. This will allow more room for access to the bulb holders.

4. At the rear of the headlamp unit, pull up on the T grip release mechanism and hold while sliding the headlamp unit forward 40mm.

Removing a headlamp bulb;

1. At the back of the headlamp unit, remove

1. At the back of the headlamp unit, remove the cover. Turn it counter clockwise to release.

2. The back of the bulb unit will now be exposed. Pull down on the electrical connector to release it from the bulb unit.

3. Turn the retaining collar counter clockwise to release the bulb. Remove the bulb unit from the housing.

READ NEXT:

 Direction indicator and side lamp bulbs

Removing the nearside bulbs; To gain more room for accessibility, follow steps 1 and 2 for moving the nearside headlamp unit. 1. At the back of the headlamp unit, remove the indicator bulb hous

 Rear lamp bulbs

1. Remove the two fixings. 2. Direction indicator. 3. Reversing lamp Turn the relevant bulb holder counter clockwise and pull to remove from the lamp unit. Grip the holder then press the bulb i

 Rear fog lamp

Access to the rear fog lamp requires special tools and should be undertaken only by a qualified technician. If in doubt, consult your Land Rover Dealer/Authorised Repairer.

SEE MORE:

 Inner Quarter Panel

Removal NOTES: The inner quarter panel is manufactured from mild steel. There are NVH components on this panel, they are not serviced on the new panel. If damaged, new components will be required. 1. The front inner quarter panel is replaced in conjunction with: Rear bumper cover Quarter panel

 Intake Air Distribution and Filtering - GTDi 2.0L Petrol

Intake Air Distribution and Filtering - Component Location COMPONENT LOCATION Purge hose from charcoal canister Clean air purge hose Clean air inlet ducts Camshaft cover vent pipe connection Sound generator duct Sound generator Air cleaner housing Dirty air intake duct Sound generator hos

© 2011-2024 Copyright www.rrevoque.org