Dodge Nitro: Hazard warning flasher
The Hazard Warning Flasher switch is located on the lower switch bank below the climate controls.
Press the switch to turn on the Hazard Warning flasher. When the switch is activated, all directional turn signals will flash on and off to warn oncoming traffic of an emergency. Press the switch a second time to turn off the Hazard Warning flasher. This is an emergency warning system and should not be used when the vehicle is in motion. Use it when your vehicle is disabled and is creating a safety hazard for other motorists. If it is necessary to leave the vehicle to go for service, the HazardWarning flasher will continue to operate with the ignition key removed and the vehicle locked.
NOTE: With extended use, the Hazard Warning flasher may wear down your battery.
If your engine overheats
In any of the following situations, you can reduce the potential for overheating your engine by taking the appropriate action. • On the highways — slow down. • In city traffic — while ...See also:
iPod Error Messages
If you see an error message on the
screen while playing an iPod, find
the solution in the chart to the right.
If you cannot clear the error
message, take your vehicle to your
dealer.
...
Stalled adjustment
If seat
movement stops unexpectedly
during adjustment check for any
obstructions and remove.
Once any obstructions have been removed the
seat adjustment mechanism can be reset as
follows.
Ope ...
To increase the speed (by accelerator pedal)
1. Depress the accelerator pedal to
accelerate the vehicle to the desired
speed.
2. Push the “SET/COAST” button once.
Now the desired speed is set and the
vehicle will keep running at that ...