Range Rover Evoque: Engine malfunction (amber)
Engine malfunction (amber)
Illuminates briefly when the
ignition is switched on. If the lamp
flashes or illuminates at any other
time, there is a fault with the engine.
Avoid high speeds and seek qualified
assistance urgently.
READ NEXT:
General warning/information message (amber)
Illuminates when a non-critical
warning message or an
information message is available in
the message centre.
Brake systems (amber)
Illuminates briefly when the
ignition is switched on. If the lamp
illuminates after starting the
engine or while driving, suspect worn brake
pads or a fault with the Emerg
Dynamic stability control (amber)
Illuminates briefly when the
ignition is switched on and
extinguishes when the engine is
started. If the lamp flashes while driving, the
DSC system is active.
SEE MORE:
Special Tool(s)
303-1565
Locking Tool, Camshaft
308-511
Installer, Transmission Output Shaft Seal
JLR-303-1594
Locking Tool, Driveplate
JLR-303-748
Locking Tool, Crankshaft
Activation
1.
2. Install the special tool.
Special Tool(s): JLR-303-748
3. Rotate the engine clockwise until the crankshaft
If the lighting has just
been switched
off, give the bulbs time to cool.
Handling them when hot may cause
personal injury.
Always replace bulbs with
the correct
type and specification. If you are in any
doubt contact your Land Rover
Dealer/Authorised Repairer for advice.
See 199, BULB
© 2011-2024 Copyright www.rrevoque.org