Range Rover Evoque: Changing a bulb
If the lighting has just
been switched
off, give the bulbs time to cool.
Handling them when hot may cause
personal injury.
Always replace bulbs with
the correct
type and specification. If you are in any
doubt contact your Land Rover
Dealer/Authorised Repairer for advice.
See 199, BULB SPECIFICATION
CHART.
Before attempting a bulb change,
ensure that the ignition and affected
lamp are turned off. If the circuit
remains live, a short circuit can occur
which may damage the vehicle
electrical system.
Not all bulbs are replaceable. The following
bulbs can be replaced:
- Headlamps.
- Direction indicators.
- Side lamps.
- Reversing lamp.
- Rear fog lamp.
- Some interior lamps.
All other exterior lamps and some interior
lamps are LED (light emitting diode) lamps and
can be replaced only by a Land Rover
Dealer/Authorised Repairer.
All replacement procedures require the
removal of components to gain access to the
bulbs.
Moving a headlamp unit
should be
undertaken only by a qualified
technician. If in doubt, consult your
Land Rover Dealer.
Note: To change any bulb in a headlamp unit, a
cross head screwdriver and a 10mm spanner is
required.
READ NEXT:
High voltage is required to
ignite the
gas and metal vapour which are used
to power Xenon lamps. Contact with
this voltage can cause serious injury.
Replacement or maintenance of
Xenon lamps s
Moving the nearside headlamp unit to access
bulbs;
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
This will allow more room for
manoeuvrability.
3. Remove
Removing the nearside bulbs;
To gain more room for accessibility, follow
steps 1 and 2 for moving the nearside
headlamp unit.
1. At the back of the headlamp unit, remove
the indicator bulb hous
SEE MORE:
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
Vehicles with automatic transmission
2. Refer to: Floor Console (501-12 Instrument Pan
Component Location
COMPONENT LOCATION
Heater assembly
Electric booster heater
Overview
OVERVIEW
Due to the slower warm up times associated with the diesel engine, an
electric booster heater may be fitted to increase
heater performance. The electric booster heater does this by heating the air
© 2011-2024 Copyright www.rrevoque.org