Range Rover Evoque: Easy entry/exit

When Easy entry/exit is configured, the driver’s seat will automatically lower when the ignition is switched off and the door release lever is used. Upon returning to the vehicle, when the driver’s door is closed and the seat belt is fastened, the seat will return to it’s previously set position.

Note: Some vehicle specifications require the ignition to be turned on.

See 56, VEHICLE INFORMATION AND SETTINGS MENU.

READ NEXT:

 Head restraints

Adjust the head restraint so that the top of the head restraint is above the centre line of the head. An incorrectly adjusted head restraint increases the risk of death or serious injury in the

 Integrated head restraints

Models with ‘sports’ seats have non adjustable and non removable head restraints.

 Rear seat access (coupe models)

The front seats tilt and power slide forwards for entry to and exit from the rear seats. Operation is controlled by a lever and switch. 1. Lift the locking lever and pivot the seatback forwards.

SEE MORE:

 Electronic Engine Controls - Component Location

Component Location COMPONENT LOCATION - SHEET 1 OF 4 Fuel metering valve - HP Fuel pump Camshaft Position (CMP) sensor (2 off) Variable Camshaft Timing (VCT) solenoid (2 off) Purge valve Generator Air Conditioning (A/C) compressor clutch Crankshaft Position (CKP) sensor Turbocharger wasteg

 Halfshaft Seal RH Vehicles With: M66 6-Speed Manual Transmission AWD

Special Tool(s) 303-1300 Remover, Crankshaft Seal 303-882 Installer, Halfshaft Seal Removal 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Front Drive Halfshafts, Removal and Installation). 3. CA

© 2011-2024 Copyright www.rrevoque.org