Range Rover Evoque: Head restraints

that the Adjust the head restraint so that the top of the head restraint is above the centre line of the head. An incorrectly adjusted head restraint increases the risk of death or serious injury in the event of a collision.
Do not drive, or carry passengers with the head restraints removed from occupied seats. The absence of a correctly adjusted head restraint increases the risk of neck injury in the event of a collision.
Never adjust the head restraints while the vehicle is in motion.
Always store a removed head restraint securely.

1. Move the head restraint up or down to the

1. Move the head restraint up or down to the required position.

2. Press the locking collar to adjust the restraint downwards.

Manual head restraints can be removed, if required. Raise the head restraint to its uppermost position and press the locking collar (3). Lift the restraint out of the seatback.

Note: Head restraints fitted with Rear seat entertainment screens must NOT be removed.

Ensure the head restraint is refitted before the seat is used by a passenger.

To refit the head restraint, ensure it is facing the correct direction, insert the stems of the head restraint into the sockets and push it downwards until at least the first click.

READ NEXT:

 Integrated head restraints

Models with ‘sports’ seats have non adjustable and non removable head restraints.

 Rear seat access (coupe models)

The front seats tilt and power slide forwards for entry to and exit from the rear seats. Operation is controlled by a lever and switch. 1. Lift the locking lever and pivot the seatback forwards.

 Rear seats

SEE MORE:

 Lower Arm

Removal CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. NOTES: RH illustration shown, LH is similar. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the ve

 Transfer Case Connecting Sleeve Seals TD4 2.2L Diesel, Vehicles With: M66 6-Speed Manual Transmission AWD

Special Tool(s) 100-012 Slide Hammer 303-1300 Remover, Crankshaft Seal 303-538 Remover/Installer, Crankshaft Oil Seal 307-594 Installer, Seal 307-595 Installer, Intermediate Shaft Seal 308-615 Remover, Seals Removal NOTE: Some variation in the illustrations may occur, but the essential information

© 2011-2024 Copyright www.rrevoque.org