Hyundai Tucson: Checking the brakes - Do-it-yourself maintenance - Hyundai Tucson Owner's ManualHyundai Tucson: Checking the brakes

CAUTION: Because brakes are essential to the safe operation of the car, it is suggested that they be checked and inspected by your Hyundai dealer. The brakes should be checked and inspected for wear at those intervals specified in the vehicle maintenance schedule.

Checking the Brake Fluid Level

WARNING: Use caution when handling brake fluid. It can damage your vision if it gets into your eyes. It will also damage your vehicle's paint if spilled on it and not removed immediately.

Recommended Brake Fluid

Use only hydraulic brake fluid conforming to DOT 3 or DOT 4 specifications in your braking system. Follow the instructions printed on the container.

To Check the Fluid Level To Check the Fluid Level

The fluid level in the brake fluid reservoir should be checked periodically. The level should be between the "MIN" and "MAX" marks on the side of the reservoir. If the level is at or below the "MIN" mark, carefully add fluid to bring it up to "MAX". Do not overfill.

Adding Brake Fluid

WARNING: Handle brake fluid carefully. It can damage your vision if it gets into your eyes. Use only DOT 3 or DOT 4 specification fluid from a sealed container. Do not allow the fluid can or reservoir to remain open any longer than required. This will prevent entry of dirt and moisture which can damage the brake system and cause improper operation.

To add brake fluid, first wipe away any dirt then unscrew the fluid reservoir cap. Slowly pour the recommended fluid into the reservoir. Do not overfill. Carefully replace the cap on the reservoir and tighten.

    Checking the transaxle fluid (automatic)
    Transaxle fluid in the automatic transaxle should be checked at those intervals specified in the vehicle maintenance schedule in Section 5. NOTE: Automatic transaxle fluid is basically red co ...

    Checking the clutch fluid
    To Check the Clutch Fluid The clutch fluid level in the master cylinder should be checked when performing other under hood services. The system should be checked for leakage at the same time ...

    See also:

    Installation with LATCH system (second outside seats only)
    Fold the seatback while pulling the lever. Return the seatback and secure it at the 1st lock position (most upright position). Adjust the seatback to the 7th lock position. 1st lock position ...

    Switching on the ignition
    To turn on the ignition without starting the engine: - Do not depress the brake/clutch pedal, - Press the START/STOP button and hold until the warning lamps illuminate, then release the button. ...

    Storing a Flat or Spare Tire and Tools
    WARNING Storing a jack, a tire, or other equipment in the passenger compartment of the vehicle could cause injury. In a sudden stop or collision, loose equipment could strike someone. Store all t ...