Hyundai Tucson: Checking the clutch fluid - Do-it-yourself maintenance - Hyundai Tucson Owner's ManualHyundai Tucson: Checking the clutch fluid

To Check the Clutch Fluid To Check the Clutch Fluid

The clutch fluid level in the master cylinder should be checked when performing other under hood services. The system should be checked for leakage at the same time. Check to make certain that the clutch fluid level is always between the "MAX" and "MIN" level markings on the fluid reservoir. Fill as required. Fluid loss indicates a leak in the clutch system which should be inspected and repaired immediately. Consult your Hyundai dealer.

To Replace the Fluid

Recommended brake fluid conforming to DOT 3 or DOT 4 specification should be used. The reservoir cap must be fully tightened to avoid contamination from foreign matter or moisture.

NOTE: Do not allow any other liquids to contaminate the brake fluid. Seal damage will result.

WARNING: Use caution when handling brake fluid. It can damage your vision if you get it in your eyes. It will also damage your vehicle's paint if spilled on it and not removed immediately.

    Checking the brakes
    CAUTION: Because brakes are essential to the safe operation of the car, it is suggested that they be checked and inspected by your Hyundai dealer. The brakes should be checked and inspected ...

    Air cnditioning care
    Keeping the Condenser Clean The air conditioning condenser (and engine radiator) should be checked periodically for accumulation of dirt, dead insects, leaves, etc. These can interfere with max ...

    See also:

    Using panic alarm
    If you are near your vehicle and feel threatened, you may activate the alarm to call attention as follows: 1. Push the PANIC button 3 on the Intelligent Key for more than 1 second. 2. The th ...

    Symbols and messages in the display
    ...

    Registering from redial
    1. Select the “REDIAL” menu. 2. Select the phone number by operating the “TUNE/TRACK/CH” dial. 3. Select the “STORE” menu. 4. Select the “CONFIRM” menu. 5. Select the “RECORD N ...