Nissan Rogue: Drive belts
1. Alternator
2. Water pump
3. Drive belt auto-tensioner
4. Crankshaft pulley
5. Air conditioner compressor
Be sure the ignition switch is in the OFF or LOCK position before servicing drive belts. The engine could rotate unexpectedly.
1. Visually inspect each belt for signs of unusual wear, cuts, fraying or looseness. If the belt is in poor condition or loose, have it replaced or adjusted by a NISSAN dealer.
2. Have the belts checked regularly for condition.
Jump starting
If jump starting is necessary, see “Jump starting” in the “6. In case of emergency” section. If the engine does not start by jump starting, the battery may have to be replaced. Contact a ...Spark plugs
Be sure the engine and ignition switch are off and that the parking brake is engaged securely. Be sure to use the correct socket to remove the spark plugs. An incorrect socket can dam ...See also:
Outside temperature display
The outside temperature display is in the multifunction display ().
WARNING
The outside temperature indicator is not designed to serve as an ice-warning
device and is therefore unsuitable for ...
Meter needles/gauge illumination setting (models with type A combination
meter)
When the setting is activated or deactivated,
the meter needles and gauge
illuminate and turn off as follows.
Activated:
When the driver’s door is opened while
the ignition switch is in the ...
Acc
In this position the electrical accessories
(radio, accessory power outlet, etc.) can
be used. ...