Range Rover Evoque: Before programming
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best results, fit a new battery to the hand-held transmitter of the garage door opener (or other device) before programming.
If your garage door opener receiver (located in the garage) is equipped with an antenna, ensure that the antenna is hanging straight down.
READ NEXT:
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6
Rolling code device equipment programming
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are
only 30 seconds in which to complete Step 3.
1. At the garage d
Reprogramming a single garage door opener button
To programme a device to a previously
programmed button:
1. Press and hold the desired
pre-programmed HomeLink button for at
least 20 seconds, but no longer than 30
seconds, until the indicator l
SEE MORE:
Brake systems (red)
Brake systems (red)
Illuminates briefly when the
ignition is switched on. If the lamp
illuminates while driving, suspect
low brake fluid level or a fault with the
Electronic Brake Distribution (EBD) system.
Stop the vehicle as soon as safety permits.
If the message CHECK BRAKE FLUID is
dis
Memory seats
Front seat positions can be saved to vehicle
memory.
Once you have adjusted the power operated
driver’s seat and the exterior mirrors, the
vehicle can memorise the settings for future
use. See 48, EXTERIOR MIRRORS.
1. On the driver’s seat, press the memory
store button to activate the m
© 2011-2024 Copyright www.rrevoque.org
