GMC Terrain: Back–Up Lamp
Removal of the lamp assembly is not required to replace the back-up lamp bulb.
To replace one of these lamps:
1. Open the liftgate. See Liftgate on page 2‑9.
2. Remove the interior trim access panel.
3. Turn the bulb socket counterclockwise and pull it out.
4. Pull the bulb straight out of the socket.
5. Install the new bulb.
6. Push the bulb socket in and turn it clockwise.
7. Reinstall the interior trim access panel.
Auxiliary Taillamp
To replace one of these lamps: 1. Open the liftgate. See Liftgate on page 2‑9. 2. Remove the interior trim access panel. A. Attachment Nuts B. Retaining Hook 3. Remove the five attachment ...License Plate Lamp
To replace one of these bulbs: 1. Open the liftgate partway. See Liftgate on page 2‑9. Passenger Side Shown, Driver Side Similar 2. Push the left end of the lamp assembly toward the right. ...See also:
Accessory power outlets
Power outlet below the climate controls
Power outlet in the center console
Power outlet in the cargo area
Accessory power outlets are provided
below the climate controls, in the cente ...
Reset
• press the button.
• After the “Ready” prompt, and the following beep, say
“Setup”, then “Reset”.
This will delete all phone pairing, phone book entries,
and other settings in ...
Oil check preparation
Prior to checking the oil level ensure that:
- The vehicle is on level ground.
- The engine oil is cold.
Note: If it is necessary to check the oil level
when the engine is hot, switch off the engi ...