Nissan Rogue: Antenna
Antenna
To remove the antenna, hold the bottom of the antenna and turn it counterclockwise.
To install the antenna, turn the antenna clockwise and tighten.
- To avoid damaging or deforming the antenna, be sure to remove the antenna under the following conditions.
— The vehicle enters an automatic car wash.
— The vehicle enters a garage with a low ceiling.
— The vehicle is covered with a car cover.
- Always properly tighten the antenna rod during installation. Otherwise, the antenna rod may break during vehicle operation.
VOLUME control switch
Push up or down the VOLUME control switch to increase or decrease the volume. Tuning switch Memory change (radio): Push up or down the tuning switch for less than 1.5 seconds to change the ne ...Car phone and CB radio
When installing a car phone or a CB radio in your vehicle, be sure to observe the following cautions, otherwise the new equipment may adversely affect the electronic control modules and electr ...See also:
Remote transmitter programming and programmable feature option
New transmitters can be programmed to
the engine starter system in the event that
remote transmitters are lost, stolen or
damaged. The remote engine start system
also has one programmable fe ...
Parking brake
To park the vehicle, first bring in to a complete stop, fully engage the parking
brake.
To apply
1- Pull the lever up without pushing the button at the end of hand grip.
To release
1- Pull t ...
Wind Buffeting
Wind buffeting can be described as the perception of
pressure on the ears or a helicopter-type sound in the
ears. Your vehicle may exhibit wind buffeting with the
windows down, or the sunroof or ...