Hyundai Tucson: Day/night inside rearview mirror - Features of your Hyundai - Hyundai Tucson Owner's ManualHyundai Tucson: Day/night inside rearview mirror

Manual Type Manual Type

Your Hyundai is equipped with a day/night inside rearview mirror. The "night" position is selected by flipping the tab at the bottom of the mirror toward you. In the "night" position, the glare of headlights of cars behind you is reduced.

AUTOMATIC DIMMING REAR VIEW MIRROR WITH COMPASS (If installed) AUTOMATIC DIMMING REAR VIEW MIRROR WITH COMPASS (If installed) 1. Status Indicator LED 2. Feature Control Button 3. Rear Light Sensor 4. Display Window

Automatic dimming rear view mirror controls automatically the glare of headlights of the car behind you when it turned on by pressing and holding the button for more than 3 but less than 6 seconds. It is turned off by pressing and holding the button for same time once more.

1. To operate Compass feature

Press and release the button, then the vehicle's directional heading will be displayed. Pressing and releasing the button again will turn off the display.

Heading display. - E : East. - W : West. - S : South. - N : North. ex) NE : North East.

2. Calibration procedure

Press and hold the button for more than 9 but less than 12 seconds. When the compass memory is cleared a "C" will appear in the display.

- Driving the vehicle in a circle at less than 5mph 2 times or until the compass heading appears. - Driving in a circle in right-handed direction and opposite direction are possible, and if the calibration is completed, the compass heading will appear. - Keep driving in a circle until a compass heading appears.

3. Setting the compass zone

1. Find your current location and variance zone number on the zone map.

2. Press and hold the button for more than 6 but

2. Press and hold the button for more than 6 but less than 9 seconds. The current zone number will appear in the display. 3. Press the button until the new zone number appears in the display. After you stop pressing the button in, the display will show a compass direction within a few seconds.

4. Changing Mirror Angle setting (If Installed):

Due to mirror positions being angled towards the driver, the compass mirror can also compensate for drivers seated on the Left Hand side of the vehicle (steering wheel on the LH side of the vehicle) or Right Hand side of the vehicle (steering wheel on the RH side of the vehicle).

To adjust the Left Hand, “L” or Right Hand, “R”, setting: 1. Press and hold the button for more than 12 seconds. 2. Release then press the button to toggle between “L” and “R”.

NOTE: This procedure also causes the compass to be de-calibrated.

3. To re-calibrate the compass, drive the vehicle in 2 complete circles at less than 8km/ h (5mph).

CAUTION: 1. Do not install the ski rack, antenna, etc. which are attached to the vehicle by means of a magnet. They affect the operation of the compass. 2. If the compass deviates from the correct indication soon after repeated adjustment, have the compass checked at an authorized dealer. 3. The compass may not indicate the correct compass point in tunnels or while driving up or down a steep hill. (The compass returns to the correct compass point when the vehicle moves to an area where the geomagnetism is stabilized.) 4. When cleaning the mirror, use a paper towel or similar material dampened with glass cleaner. Do not spray glass cleaner directly on the mirror as that may cause the liquid cleaner to enter the mirror housing.

    Outside rearview mirror
    Manual Type The outside rearview mirrors are equipped with a remote control for your convenience. It is operated by the control lever in the bottom front corner of the window. Before drivi ...

    Parking brake
    Applying the parking brake To engage the parking brake, first apply the foot brake and then without pressing the release button in, pull the parking brake lever up as far as possible. In add ...

    See also:

    Light bulbs
    A: HB3 halogen bulbs B: HB4 halogen bulbs C: H11 halogen bulbs D: Wedge base bulbs (clear) E: Wedge base bulbs (amber) F: Double end bulbs *: If equipped ...

    When checking or servicing in the engine compartment while the engine is running
    A running engine can be dangerous. Keep your fingers, hands, clothing, hair and tools away from the cooling fan, belts and any other moving engine parts. Removing rings, watches and ties ...

    Average fuel consumption
    Average fuel consumption 1) U.S.-spec. models 2) Except U.S.-spec. models This indication shows the average rate of fuel consumption since the trip meter was last reset. When either of th ...