Toyota RAV4: Changing display modes - Rear view monitor system (vehicles with auto anti-glare inside rear view 
mirror) - Using other driving systems - When driving - Toyota RAV4 Owner's ManualToyota RAV4: Changing display modes

The rear view monitor display mode can be changed while the screen is on.

●To temporarily disable the rear view monitor system

Push the “AUTO” button.

Push the “AUTO” button. The indicator will turn amber.

Vehicles without smart key system

The system will be re-enabled once the engine switch is turned OFF and then turned to the “ON” position.

Vehicles with smart key system

The system will be re-enabled once the “ENGINE START STOP” switch is turned OFF and then turned to IGNITION ON mode.

●To constantly disable the rear view monitor system

Push and hold the “AUTO” button for 12

Push and hold the “AUTO” button for 12 to 15 seconds. The screen will turn off and on after 6 seconds. Keep pushing the button until the screen turns back off. The indicator will flash amber.

Vehicles without smart key system

The system will not automatically turn on again after the engine switch is OFF and then turned to the “ON” position.

Vehicles with smart key system

The system will not automatically turn on again after the “ENGINE START STOP” switch is OFF and then turned to IGNITION ON mode.

●To re-enable the rear view monitor system Push the “AUTO” button. The indicator will turn green.

    The rear view monitor system can be operated when
    Vehicles without smart key system The shift lever is in R, the back door is fully closed and the engine switch is in the “ON” position. Vehicles with smart key system The shift lever is in R ...

    Selecting a language (English, French or Spanish)
    1 Push and hold the “AUTO” button for 6 to 12 seconds. The screen will turn on and the indicator will turn green. 2 Push the “AUTO” button. Each time the “AUTO” button is pushed an ...

    See also:

    Service TPMS Warning
    When a system fault is detected, the “Tire Pressure Monitoring Telltale Light” will flash on and off for 75 seconds and then remain on solid. The system fault will also sound a chime. If the ...

    Stage 2: Checking inflation pressure
    1. Connect the tire sealing system as described in stage 1. 2. Refer to the inflation pressure table in this chapter for the correct inflation pressure. If the tire needs to be inflated, start ...

    Automatic transmission models
    Automatic transmission models The key can be turned from “Acc” to “LOCK” only when the select lever is in the “P” position. ...