Mercedes-Benz GLK-Class: SRS warning lamp
SRS functions are checked regularly when you switch on the ignition and when the engine is running. Therefore, malfunctions can be detected in good time.
The SRS warning lamp in the instrument cluster lights up when the ignition is switched on. It goes out no later than a few seconds after the engine is started.
The SRS components are in operational readiness when the SRS warning lamp is not lit while the engine is running .
WARNING
The SRS self-check has detected a malfunction if the SRS warning lamp:
- does not come on at all
- fails to go out approximately 4 seconds after the engine was started
- comes on after the engine was started or while driving
For your safety, Mercedes-Benz strongly recommends that you have the system checked as soon as possible at an authorized Mercedes-Benz Center. Otherwise the SRS may not be activated when it is needed in an accident, which could result in serious or fatal injury. The SRS might also deploy unexpectedly and unnecessarily which could also result in injury.
In addition, improper work on the SRS creates a risk of rendering the SRS inoperative or causing unintended air bag deployment. Work on the SRS must therefore only be performed by qualified technicians. Contact an authorized Mercedes-Benz Center.
If it is necessary to modify an air bag system to accommodate a person with disabilities, contact an authorized Mercedes-Benz Center for details. USA only: Call our Customer Assistance Center at 1-800-FOR-MERCedes (1-800-367-6372) for details.
Introduction
SRS consists of: the SRS warning lamp air bags air bag control unit (with crash sensors) Emergency Tensioning Devices belt force limiters SRS reduces the risk of occupants coming into ...Safety guidelines for seat belts, Emergency Tensioning Devices (ETDs) and air bags
WARNING Damaged seat belts or seat belts that have been subjected to stress in an accident must be replaced. Their anchoring points must also be checked. Only use seat belts installed o ...See also:
Checking the fluid level when the fluid is cold
When the fluid level has to be checked
without time to warm up the automatic
transmission, check to see that the fluid
level is between the lower level and upper
level on the “COLD” range. ...
Traction control (TCS)
Traction control is a driver aid feature that helps your vehicle maintain
traction of the wheels, typically when driving on slippery and/or hilly
road surfaces, by detecting and controlling wheel sp ...
Exterior Lamp Controls
The exterior lamp control is on the turn signal/lane change lever.
(Exterior Lamp Control): Operates
the exterior lamps. Turn to one of the following positions:
(Off): Briefly turn to this pos ...