GMC Terrain: Windshield Wiper/Washer
The windshield wiper/washer lever is located on the right side of the steering column. With the ignition in ACC/ACCESSORY or ON/RUN/ START, move the windshield wiper lever to select the wiper speed.
HI: Use for fast wipes.
LO: Use for slow wipes.
INT: (Intermittent Wipes): Move the lever up to INT for intermittent wipes, then
turn the band up for more frequent wipes
or down for less frequent wipes.
Use to turn the wipers off.
For a single wipe, briefly move
the wiper lever down. For several wipes, hold the wiper lever down.
FRONT (Windshield Washer): Pull
the windshield wiper lever toward you to spray windshield washer fluid and activate
the wipers. The wipers will continue until the lever is released or the maximum
wash time is reached. When the windshield wiper lever is released, additional wipes
may occur depending on how long the windshield washer had been activated. See Washer
Fluid on page 10‑23 for information on filling the windshield washer fluid reservoir.
WARNING
In freezing weather, do not use the washer until the windshield is warmed. Otherwise the washer fluid can form ice on the windshield, blocking your vision.
Clear snow and ice from the wiper blades before using them. If frozen to the windshield, carefully loosen or thaw them. Damaged blades should be replaced. See Wiper Blade Replacement on page 10‑28.
Heavy snow or ice can overload the wiper motor.
Horn
Pressa on the steering wheel pad
to sound the horn. ...
Wipe Parking
If the ignition is turned to LOCK/ OFF while the wipers are on LO, HI, or INT,
they will immediately stop. If the windshield wiper lever is then moved to off before
the driver door is opened or wi ...
See also:
Audio set
Your SUBARU may be equipped with one
of the following audio sets. Refer to the
pages indicated in this section for operating
details.
NOTE
If a cell phone is placed near the audio
set, it m ...
Warnings and indicators
Warning lights / audible indicators Checking operation All warning lights are
checked by turning the ignition switch ON (do not start the engine). Any light that
does not illuminate should be chec ...
Key number plate
The key number is stamped on the key
number plate attached to the key set.
Write down the key number and keep it in
another safe place, not in the vehicle. This
number is needed to make a repla ...