Kia Sportage: Wiper blades
Wiper blade maintenance Commercial hot waxes applied by automatic car washes have been known to make the windshield difficult to clean. Contamination of either the windshield or the wiper blades with foreign matter can reduce the effectiveness of the windshield wipers. Common sources of contamination are insects, tree sap, and hot wax treatments used by some commercial car washes. If the blades are not wiping properly, clean both the window and the blades with a good cleaner or mild detergent, and rinse thoroughly with clean water.
NOTICE To prevent damage to the wiper blades, do not use gasoline, kerosene, paint thinner, or other solvents on or near them.
Windshield wiper blade replacement When the wipers no longer clean adequately, the blades may be worn or cracked, and require replacement.
NOTICE To prevent damage to the wiper arms or other components, do not attempt to move the wipers manually.
NOTICE The use of a non-specified wiper blade could result in wiper malfunction and failure.
1. Raise the wiper arm and turn the wiper blade assembly to expose the plastic locking clip.
NOTICE Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield.
2. Compress the clip and slide the blade assembly downward. 3. Lift it off the arm. 4. Install the blade assembly in the reverse order of removal.
Rear window wiper blade replacement (if equipped) 1. Raise the wiper arm and pull out the wiper blade assembly.
2. Install the new blade assembly by inserting the center part (➀) into the slot (➁) in the wiper arm until it clicks into place. 3. Make sure the blade assembly is installed firmly by gently pulling on the blade.
Climate control air filter
The climate control air filter installed behind the glove box filters the dust or other pollutants that come into the vehicle from the outside through the heating and air conditioning system. If ...Battery
WARNING - Battery dangers Always read the following instructions carefully when handling a battery. Keep lighted cigarettes and all other flames or sparks away from the battery. Hydrogen, a highly ...See also:
Entering the vehicle following remote engine start
shutdown
An alarm trigger may occur if the vehicle is
opened by the remote keyless entry
transmitter within a few seconds immediately
following remote engine start shutdown. ...
Dsc warning lamp
The amber DSC warning lamp in
the instrument panel illuminates
briefly when the ignition is
switched on and extinguishes when the engine
is started.
If the lamp flashes while driving, the DSC
...
Displaying and selecting preset stations (type D audio)
1. Press the button for 1.5
seconds
or longer during satellite radio reception to
display the radio screen.
2. Operate the “TUNE/TRACK/CH” dial
to select the stations. ...