Nissan Rogue: Window washer fluid
Type A
Type B
Fill the window washer fluid reservoir periodically.
Add window washer fluid when the low window washer fluid warning light illuminates (if so equipped).
To fill the window washer fluid reservoir, lift the cap and pour the window washer fluid into the reservoir opening.
Add a washer solvent to the water for better cleaning. In the winter season, add a windshield washer antifreeze. Follow the manufacturer’s instructions for the mixture ratio.
Refill the reservoir more frequently when driving conditions require an increased amount of window washer fluid.
Recommended fluid:
Genuine NISSAN Windshield Washer Concentrate
Cleaner & Antifreeze or equivalent
- Do not substitute engine anti-freeze coolant for window washer solution.
This may result in damage to the paint.
- Do not fill the window washer reservoir tank with washer fluid concentrates at full strength. Some methyl alcohol based washer fluid concentrates may permanently stain the grille if spilled while filling the window washer reservoir tank.
- Pre-mix washer fluid concentrates with water to the manufacturer’s recommended levels before pouring the fluid into the window washer reservoir tank. Do not use the window washer reservoir tank to mix the washer fluid concentrate and water.
Brake fluid
For additional brake fluid information, see
“Capacities and recommended fuel/lubricants”
in the “9. Technical and consumer information”
section of this manual.
- Use only new fluid ...
Battery
- Keep the battery surface clean and dry.
Clean the battery with a solution of baking
soda and water.
- Make certain the terminal connections are
clean and securely tightened.
- If the vehicle ...
See also:
Manual Operation of Power Liftgate
To change the liftgate to manual operation, turn the mode switch to the OFF position.
With the power liftgate disabled and all of the doors unlocked, the liftgate
can be manually opened and closed. ...
Activating and deactivating the alarm system
To change the setting of your vehicle’s
alarm system for activation or deactivation,
do the following.
1. Disarm the alarm system. Refer to
“Disarming the system”.
2. Sit in the driver ...
Place/Retrieve A Call From Hold
To put a call on hold, press the
button until you hear
a single beep. This indicates that the call is on hold. To
bring the call back from hold, press and hold the
button until you hear a s ...
