Range Rover Evoque: Window reset
If the battery is disconnected or the power
supply is interrupted, the windows must be
reset.
Once the power supply is restored, reset as
follows:
1. Close the window fully.
2. Release the switch, then lift it to the close
position and hold for 1 second.
3. Repeat the procedure on each window.
READ NEXT:
Closing a window or roof
blind onto
any part of the body can result in
serious injury.
Before closing a window or the roof
blind, ensure that no occupants have
any part of their body in a posi
if a resonance or booming sound occurs when
a rear window is open, lowering an adjacent
front window by approximately 25mm (1 inch)
will eliminate the condition.
SEE MORE:
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information,
Description and Operation).
2. Refer to: Instrument Panel - TD4 2.2L Diesel (501-12 Instrument
Panel and Console, Removal a
Special Tool(s)
307-597
Installer, Torque Converter Seal
307-613
Holding Pins, Torque Converter
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
© 2011-2024 Copyright www.rrevoque.org