Voice control operation
1. Voice button: Press briefly to start a voice
session. A pop up will appear on the touch
screen. Press and hold to cancel a voice
session.
Note: Briefly press the Voic
To listen to a tutorial detailing the operation of
the Voice system:
- Briefly press the Voice button to start a
voice session.
- Wait for the tone to sound, then say Voice
tutorial.
Alternative
This is a feature designed to enable the system
to better recognise the vocal characteristics of
a user, once the training has been completed.
To carry out Voice training:
- Select Setup from the
TRANSMISSION CONTROL MODULE (TCM)
TCM
Neutral 'N' position
Park 'P' position
Position sensor/manual shaft
Electrical connector
The TCM is located on the top of the transmission casing and is connected on
the high speed CAN (controller area network)
bus to send and receive information to and
Rear Differential Control Module (RDCM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle.
NOT