Subaru Forester: To turn off fuel consumption indicator display
The fuel consumption indicator display can be turned off.
To turn off this display, turn the ignition switch to the “LOCK” position and press the “+” button adjacent to the information display for approximately 5 seconds.
Then, the information display and the clock display will blink for 3 seconds to notify you that the fuel consumption display has been turned off.
To restore the indicator, once again press the “+” button for approximately 5 seconds.
NOTE
- The initial display setting of the fuel
consumption indicator of your vehicle
has been set to operational at the time
of shipment from the factory.
- The average fuel consumption is calculated even while the indicator is not displayed.
- Even if you turn off the fuel consumption indicator, the fuel consumption indicator will automatically turn on when the battery voltage is disconnected and then reconnected for battery replacement or fuse replacement.
Average fuel consumption
Average fuel consumption 1) U.S.-spec. models 2) Except U.S.-spec. models This indication shows the average rate of fuel consumption since the trip meter was last reset. When either of th ...Light control switch
The light control switch only operates when the ignition key is inserted into the ignition switch. Regardless of the position of the light control switch, the illuminated lights are turned of ...See also:
Brake fluid
For additional brake fluid information, see
“Capacities and recommended fuel/lubricants”
in the “9. Technical and consumer information”
section of this manual.
- Use only new fluid ...
Entry by town
If a town name is entered first, the points of
interest listed will be restricted to that town.
- From the Input POI Name screen, touch
Town.
- Enter the town name required.
- Touch List to displ ...
Scanning
SCAN automatically searches through the list
of satellite channels. The search will only be
carried out in the selected category, see
page 215 for more detailed information on the
scan functio ...