Jeep Liberty: To Accelerate For Passing
Press the accelerator as you would normally. When the pedal is released, the vehicle will return to the set speed.
Using Electronic Speed Control On Hills
The transmission may downshift on hills to maintain the vehicle set speed.
NOTE: The Electronic Speed Control system maintains speed up and down hills. A slight speed change on moderate hills is normal.
On steep hills, a greater speed loss or gain may occur so it may be preferable to drive without Electronic Speed Control.
WARNING!
Electronic Speed Control can be dangerous where the
system cannot maintain a constant speed. Your vehicle
could go too fast for the conditions, and you
could lose control and have an accident. Do not use
Electronic Speed Control in heavy traffic or on roads
that are winding, icy, snow-covered or slippery.
To Vary The Speed Setting
When the Electronic Speed Control is set, you can increase
speed by pushing the RES (+) button. If the button
is continually pressed, the set speed will continue to
increase until the button is ...
Parksense Rear Park Assist — If Equipped
The ParkSense Rear Park Assist system provides visual
and audible indications of the distance between the rear
fascia and a detected obstacle when backing up, e.g.
during a parking maneuver. Refe ...
See also:
Instrument brightness control
The instrument brightness control operates
when the headlight switch is in the or
position.
Turn the control A to adjust the brightness of
the meter panel and the instrument panel lights.
...
Security
OnStar provides services like Stolen Vehicle Assistance, Remote Ignition Block,
and Roadside Assistance, if the vehicle is equipped with these services. OnStar
can unlock the vehicle doors remotel ...
Pre-heating or pre-cooling the interior of the
vehicle
Before exiting the vehicle, set the temperature
controls to the desired setting
and operation. After the system starts the
vehicle, the heater or air-conditioning will
activate and heat or coo ...
