Toyota RAV4: Switching the door unlock function - Antenna location and effective range - Opening, closing and locking the doors - Before driving - Toyota RAV4 Owner's ManualToyota RAV4: Switching the door unlock function

It is possible to set which doors the entry function unlocks.

1 Turn the “ENGINE START STOP” switch OFF. 2 When the indicator on the key surface is turned off, push and hold while pushing on the key.  for approximately 5 seconds while pushingThe setting changes each time an operation is performed, as shown below. on the key.

The setting changes each time an operation is performed, as shown below. (When changing the setting continuously, release the buttons, wait for at least 5 seconds, and repeat step 2.)

Battery-saving function

    Conditions affecting operation
    The smart key system uses weak radio waves. In the following situations, the communication between the electronic key and the vehicle may be affected, preventing the smart key system and wireless re ...

    Battery-saving function
    In the following circumstances, the entry function is disabled in order to prevent the vehicle and electronic key batteries from discharging. ●When the entry function has not been used for 2 ...

    See also:

    Rear seatbelts (except rear center seatbelt)
    1. Sit well back in the seat. 2. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted. If the belt stops before reaching the buckle, return the belt slightly and pul ...

    Instant Fuel Economy
    This display shows the instant fuel economy you are getting. It shows the number of mpg (U.S.) or l/100 km (Canada). ...

    Tire inspection
    Check on a daily basis that the tires are free from serious damage, nails, and stones. At the same time, check the tires for abnormal wear. Contact your SUBARU dealer immediately if you find ...