Range Rover Evoque: Switching off the engine with the vehicle moving
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Switching off the engine with the vehicle moving
It is not advisable to switch
off the
engine while the vehicle is moving.
However, should such a situation arise, then the following procedure applies.
- Press and hold the engine START/STOP button for 2 seconds, or; - Press the engine START/STOP button twice within 2 seconds.
In either case, the warning Engine Stop Button Pressed will be displayed in the message centre.
READ NEXT:
Rolling re-start
If the engine is switched off while the vehicle is
moving, a rolling re-start can be initiated.
Automatic transmission - select neutral (N) and
then press the engine START/STOP button.
When the en
Keyless start backup
If the vehicle has been unlocked using the
emergency key blade or the Smart Key is not
detected by the vehicle, it will be necessary to
use the keyless start backup to disarm the
alarm and start t
Stop/start (manual transmission only)
The Stop/Start system has been designed to
improve fuel efficiency. The system is
automatically activated when the ignition is
switched on.
When the engine has been stopped by the
stop/start syst
SEE MORE:
Control Diagram
NOTES:
A = Hardwired; N = Medium Speed CAN (controller area network) bus; D =
High Speed CAN bus; T = Coaxial; O =
LIN (local interconnect network) bus; P = Fibre Optic MOST; AD = NSTC; AE = LVDS;
Park assist is not available to all markets.
CONTROL DIAGRAM - SHEET 1 OF 3 - PARKING AID AND PARK ASS
Rocker Panel Inner Reinforcement
Removal
NOTES:
The rocker panel inner reinforcement is manufactured from boron steel.
The rocker panel inner reinforcement is unpicked from the side panel
reinforcement 'ring-frame', it is not serviced separately.
In this procedure the b-pillar reinforcement will be fitted in combination with
th
© 2011-2024 Copyright www.rrevoque.org
