Subaru Forester: Starting the engine
Do not operate the starter motor continuously for more than 10 seconds.
If the engine fails to start after operating the starter for 5 to 10 seconds, wait for 10 seconds or more before trying again.
NOTE
It may be difficult to start the engine
when the battery has been disconnected
and reconnected (for maintenance
or other purposes). This difficulty
is caused by the electronically
controlled throttle’s self-diagnosis
function. To overcome it, keep the
ignition switch in the “ON” position
for approximately 10 seconds before
starting the engine.
Preparing to drive
You should perform the following checks and adjustments every day before you start driving. 1. Check that all windows, mirrors, and lights are clean and unobstructed. 2. Check the appearance a ...MT models
1. Apply the parking brake. 2. Turn off unnecessary lights and accessories. 3. Press the clutch pedal to the floor and shift the shift lever into neutral. Hold the clutch pedal to the floor whil ...See also:
Manual transmission
Manual transmission
Selection of reverse gear is
prevented
when the vehicle is travelling in excess
of 24km/h (15mph). Never attempt to
engage reverse gear while the vehicle is
in forward mo ...
Selecting a folder
■ Selecting folders one at a time
To select the desired folder, press
■ Selecting a folder and file from folder list
1 Press .
The folder list will be displayed.
2 Turn and press&n ...
Interior lights
Room light Front (map light) The lights are turned ON or OFF by pressing the
corresponding switch.
Center (dome light) ➀ DOOR : The light turns on or off when a door is opened
or close ...