Subaru Forester: Sounding a panic alarm
Sounding a panic alarm
A “PANIC” button is located on the back of the transmitter.
To activate the alarm, press the “PANIC” button once.
The horn will sound and the turn signal lights will flash.
To deactivate the panic alarm, press any button on the remote transmitter. Unless a button on the remote is pressed, the alarm will be deactivated after approximately 30 seconds.
Vehicle finder function
Use this function to find your vehicle parked among many vehicles in a large parking lot. Provided you are within 30 feet (10 meters) of the vehicle, pressing the “” button three times in ...Selecting turn signal lights operation
When the remote keyless entry system is used, the turn signal lights flash. However, the turn signal lights flashing operational non-operational setting can be changed. Models with genuine SUBA ...See also:
Removing the mechanical key
Push release catch 1 in the direction of the arrow and at the same time,
remove mechanical key 2 from the SmartKey.
...
Pre-heating or pre-cooling the interior of the
vehicle
Before exiting the vehicle, set the temperature
controls to the desired setting
and operation. After the system starts the
vehicle, the heater or air-conditioning will
activate and heat or coo ...
Decoupling a trailer
WARNING
Do not disconnect a trailer with an engaged overrun brake. Otherwise, your hand
could become trapped between the bumper and trailer drawbar.
Do not disconnect a trailer with an eng ...