Jeep Liberty: Reset
It may be necessary at some point in time to reactivate the Auto Up feature. To do so, perform the following procedure:
1. Pull the window switch up to close the window completely and continue to hold the switch up for an additional two seconds after the window is closed.
2. Push the window switch down firmly to the second detent to open the window completely and continue to hold the switch down for an additional two seconds after the window is fully open.
Auto Up Feature With Anti-Pinch Protection — If Equipped
On some models, the driver’s and front passenger’s (if
equipped for passenger side) power window switches
have an “Auto Up” feature. Pull the window switch fully
upward to the second det ...
Window Lockout Button
The window lockout button on the driver’s door trim
panel allows you to disable the window control on the
rear doors. To disable the window control on the other
doors, press and release the wi ...
See also:
How To Engage The Automatic Locking Mode
1. Buckle the combination lap and shoulder belt.
2. Grasp the shoulder portion and pull downward until
the entire belt is extracted.
3. Allow the belt to retract. As the belt retracts, you will
...
How to Check Lubricant
To get an accurate reading, the vehicle should be on a level surface.
If the level is below the bottom of the fill plug hole, located on the transfer
case, the vehicle will need some lubricant ad ...
Voice guidance
To turn voice guidance on or off but maintain
route guidance, proceed as follows:
1. Touch Nav menu on the map menu screen.
2. Touch the Route voice guidance soft key.
The soft key will be highlig ...
