Volvo XC60: Reprogramming a Single HomeLink Button
To program a device to HomeLink using a HomeLink button previously trained, follow these steps:
1. Press and hold the desired HomeLink button.
DO NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the Home- Link button, proceed with “Programming” - step 1.
For questions or comments, contact HomeLink at: www.homelink.com or 1–800–355–3515.
This device complies with FCC rules part 15 and Industry Canada (IC) RSS-210. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference that may be received including interference that may cause undesired operation.
NOTE
The transmitter has been tested and complies
with FCC and IC rules. Changes or
modifications not expressly approved by
the party responsible for compliance could
void the user’s authority to operate the
device.
Erasing HomeLink Buttons
To erase programming from the three Home- Link buttons (individual buttons cannot be erased but can be “reprogrammed” as outlined below), follow the step noted: 1. Press and hold the two ou ...See also:
Tilt/telescopic steering wheel
- Do not adjust the steering wheel
tilt/telescopic position while driving.
This may cause loss of
vehicle control and result in
personal injury.
- If the lever cannot be raised to
the fi ...
Meters and gauges
Meters and gauges
1. Tachometer
2. Vehicle information display
3. Speedometer
4. Warning/indicator lights
5. Engine coolant temperature gauge
6. switch (twin trip odometer
control and ...
Cruise eco data
Diesel only
When enabled, a CO2 emission indicator is
displayed in the message centre. The higher
the numeric reading, the more CO2 is being
emitted and the more fuel is being used. See
56, VEH ...