Ford Escape: Replacing license plate lamp bulbs
1. Make sure the headlamp switch is
in the off position.
2. Press the lever and carefully pry
the license plate lamp assembly
(located above the license plate)
from the liftgate.
3. Rotate the bulb socket
counterclockwise and remove from
lamp assembly.
4. Pull bulb straight out of socket
and push in the new bulb.
5. Install the bulb socket into the
lamp assembly and rotate clockwise.
6. To install, carefully press the
lamp assembly into liftgate.
Replacing high-mount brake lamp bulbs
1. Remove the two screws and move
the lamp assembly away from the
liftgate.
2. Remove the bulb holder from the
lamp assembly by pressing the
snaps.
3. Pull the bulb straight out of the
sock ...
Replacing fog lamp bulbs (if equipped)
1. Make sure the fog lamp switch is
in the off position.
2. From underneath the vehicle,
carefully disconnect the electrical
connector from the bulb.
3. Remove the bulb from the lamp
assembly by ...
See also:
When “CHECK DEVICE” is displayed
This message is displayed under the
following conditions.
- When there is a short in the USB bus
- When a non-corresponding device (for
example a USB mouse) is connected
- When a non-correspo ...
SmartKey
0 To remove the SmartKey (shift the transmission to position P)
1 Power supply for some consumers, such as the windshield wipers
2 Ignition (power supply for all consumers) and drive position
3 T ...
Overhead Console Box (if equipped)
Overhead Console
Box (if equipped)
To use the overhead console box, push on the front edge (1) and open the lid.
To close the lid, push the front edge (1) until it latches. Do not put heavy or
...
