Subaru Forester: Replacing an air filter
1. Remove the glove box.
(1) Open the glove box.
(2) Remove the damper shaft from the glove box.
(3) Pull out the glove box.
2. Remove the air filter.
3. Replace the air filter element with a new one.
The arrow mark on the filter must point UP.
4. Reinstall the glove box, and connect the damper shaft.
5. Close the glove box.
6. LABEL installation
(1) Fill out the information on the
service label (small).
1) Service label
(2) Attach the service label to the driver’s side door pillar.
1) Caution label
(3) Attach the caution label next to the air filter as shown in the illustration.
Air filtration system
Replace the filter element according to the replacement schedule as follows. This schedule should be followed to maintain the filter’s dust collection ability. Under extremely dusty conditio ...Audio
...See also:
Rear control panel with headphone sockets
Headphones with an impedance of
16 – 32 ohm and sensitivity of 102 dB or higher
are recommended for best sound reproduction.
1 Volume control (right/left sides).
2 Scroll/search forward and ...
Air conditioning
The vehicle is equipped with Electronic Climate
Control (ECC). The climate control system
cools, heats or dehumidifies the air in the passenger
compartment.
NOTE
• The air conditioning can b ...
Selection Of Lubricant
It is important that the proper lubricant is used in the
transmission to assure optimum transmission performance.
Use only manufacturer’s recommended transmission
fluid. Refer to “Fluids, Lub ...