Subaru Forester: Rear wiper
To turn the rear wiper on, turn the knob on the end of the wiper control lever upward to the “INT” or “ON” position.
To turn the wiper off, return the knob on the end of the lever to the “OFF” position.
With the switch turned to the “INT” position, the rear wiper will operate intermittently at intervals corresponding to the vehicle speed (longer when the vehicle speed is low; shorter when the vehicle speed is high).
When the transmission is shifted into reverse, the rear wiper will switch to continuous operation. When the transmission is shifted to a position other than reverse, the rear wiper will return to intermittent operation.
Rear window wiper and washer switch
Rear window wiper and washer switch
Washer (accompanied by wiper
operation)
ON: Continuous
INT: Intermittent
OFF: Off
Washer ...
Washer
To wash the rear window while the rear
wiper is operating, turn the knob clockwise
to the “” position. The washer fluid
sprays until you release the knob.
To wash the rear window when the r ...
See also:
Parking brake
1 Sets the parking brake
Fully apply the parking brake while depressing the brake pedal.
2 Releases the parking brake
Slightly raise the lever and lower it completely while pressing the button. ...
Tire rotation
Models equipped with 4 non-unidirectional tires
1) Front
Models equipped with unidirectional tires
1) Front
Tire wear varies from wheel to wheel. To
maximize the life of each tire and ensure ...
Rear-facing child restraint installation using the
seat belts
The three-point seat belt with Automatic
Locking Retractor (ALR) must be
used when installing a child restraint.
Failure to use the ALR mode will result
in the child restraint not being p ...
