Ford Escape: Panel dimmer control
Use to adjust the brightness of the instrument panel and all applicable switches in the vehicle during headlamp and parking lamp operation.
• Move the control to the full
upright position, past detent, to
turn on the interior lamps.
• Rotate to full down position (past
detent) to prevent interior lamps
from illuminating when the doors are opened.
Note: If the battery is disconnected, discharged, or a new battery is
installed, the dimmer switch requires re-calibration. Rotate the dimmer
switch from the full dim position to the full dome/on position to reset.
This will ensure that your displays are visible under all lighting conditions.
Daytime running lamps (DRL) (if equipped)
Turns the low beam headlamps on with a reduced output.
To activate:
• the ignition must be in the on position.
• the headlamp control must be in the off, parking lamps or autolamp
position ...
Aiming the headlamps
The headlamps on your vehicle are properly aimed at the assembly plant.
If your vehicle has been in an accident, the alignment of your headlamps
should be checked by your authorized dealer.
Verti ...
See also:
Rear window wiper blade assembly
1. Raise the wiper arm off the rear
window.
2. Turn the wiper blade assembly counterclockwise.
3. Pull the wiper blade assembly toward
you to remove it from the wiper arm.
4. Install the wi ...
Adjusting sound quality and volume balance
1 Press to enter iPod menu mode.
2 Press changes sound modes. ...
Resonance with lowered windows
if a resonance or booming sound occurs when
a rear window is open, lowering an adjacent
front window by approximately 25mm (1 inch)
will eliminate the condition. ...
