Subaru Forester: P (Park) - Select lever - Automatic transmission - Starting and operating - Subaru Forester Owner's ManualSubaru Forester: P (Park)

This position is for parking the vehicle and starting the engine.

In this position, the transmission is mechanically locked to prevent the vehicle from rolling freely.

When you park the vehicle, first set the parking brake fully, then shift into the “P” position. Do not hold the vehicle with only the transmission.

To shift the select lever from the “P” to any other position, you should depress the brake pedal fully then move the select lever. This prevents the vehicle from lurching when it is started.

    Select lever
    : Shifting is possible with the brake pedal depressed. : Shifting is possible whether the brake pedal is depressed or not. However, while the ignition switch is in the “LOCK” ...

    R (Reverse)
    This position is for backing the vehicle. To shift from the “N” to “R” position, stop the vehicle completely then move the lever to the “R” position. When the ignition switch has bee ...

    See also:

    Locking
    1. Switch off the engine (see page 114 for details). 2. Remove the remote key from the ignition slot. 3. Open the driver's door. > A sound will be audible when the steering wheel lock enga ...

    Improving Fuel Economy
    The following instructions will help you improve fuel economy. Avoid excessive idling If you are to wait for more than a minute while you are parked, stop the engine and start it again later. When ...

    Label information
    There are several important labels and identification numbers located on your vehicle. The label locations are identified in the illustrations shown. Vehicle identification number (VIN) To check t ...