Volvo XC60: Operation and function - Driver Alert System - Comfort and driving pleasure - Volvo XC60 Owner's ManualVolvo XC60: Operation and function

LDW can be switched on or off by pressing the

LDW can be switched on or off by pressing the button on the center console. A light in the button illuminates when the function is on.

The trip computer display shows Lane Depart Warn Standby <40 mph (Lane Depart Warn Standby <65 km/h) when the function is in standby mode.

When LDW is in standby mode, the function is activated automatically after the camera has monitored the road’s side marker lines and the vehicle’s speed exceeds 40 mph (65 km/h).

Lane Depart Warn Available will be displayed.

If the vehicle’s speed falls below 37 mph (60 km/h), LDW will return to standby mode and Lane Depart Warn Standby <40 mph (65 km/h) will be displayed.

If the camera can no longer monitor the road’s side marker lines, Lane Depart Warn Unavailable will be displayed.

If the vehicle unexpectedly crosses the lane’s left or right side marker lines, the driver will be alerted by an audible signal.

No warning signal will be given in the following situations:
• The turn signal is being used
• The driver’s foot is on the brake pedal
• The throttle pedal is pressed quickly
• If the steering wheel is moved quickly
• In sharp turns that cause the vehicle’s body to sway

See page 176 for information on the camera’s limitations.

WARNING
The driver will only be warned once for each time the wheels cross a marker line. No alarm will be given if a marker line is between the wheels.

    Lane Departure Warning (LDW)– introduction
    This function is designed to help reduce the risk of accidents in situations where the vehicle leaves its lane and there is a risk of driving off the road or into the opposite lane. LDW consis ...

    Settings
    Settings for Lane Departure Warning can be made in the menu system by pressing My Car. Go to Settings Car settings Driver support systems Lane Departure Warning. There are two alt ...

    See also:

    Lap/Shoulder Belt Operating Instructions
    1. Enter the vehicle and close the door. Sit back and adjust the seat. 2. The seat belt latch plate is located on the B-Pillar along the outboard side and rear of the seat cushion. The rear sea ...

    Calling up a stored setting
    If you want to move the seat from the fully reclined position to a stored seat position, first raise the backrest. The seat could otherwise be damaged. Press and hold the relevant storage positi ...

    Scan tuning (SCAN)
    If you press the “SCAN” button briefly (type A, B and C audio)/continuously (type D audio), the radio will switch to the scan mode. In this mode, the radio scans through the radio band u ...