Mercedes-Benz GLK-Class: Servicing the brakes
If the red brake warning lamp lights up in the instrument cluster and you hear a warning tone while the engine is running, the brake fluid level may be too low.
Observe additional warning messages in the multifunction display.
The brake fluid level may be too low due to brake pad wear or leaking brake lines. Have the brake system checked immediately. This work should be carried out at an authorized Mercedes-Benz Center.
All checks and maintenance work on the brake system must be carried out at a qualified specialist workshop. This work should be carried out at an authorized Mercedes-Benz Center.
Have the brake pads replaced and the brake fluid renewed at a qualified specialist workshop, e.g. an authorized Mercedes-Benz Center.
WARNING
If brake pads or brake fluid other than those recommended are used, the braking properties of the vehicle can be degraded to an extent that safe braking is substantially impaired. This could result in an accident.
Vehicles with 4MATIC: function or performance tests may only be carried out on a 2-axle dynamometer. If you are planning to have the vehicle tested on such a dynamometer, contact an authorized Mercedes-Benz Center to obtain further information first. Otherwise, you could damage the drive train or the brake system.
As the ESP® system operates automatically, the engine and the ignition must be switched off (SmartKey in position 0 or 1 in the ignition lock) when:
- testing the parking brake on a brake dynamometer.
- you intend to have the vehicle towed with the front or rear axle raised (not permitted for vehicles with 4MATIC).
Braking maneuvers triggered automatically by ESP® may seriously damage the brake system.
If your brake system is subject only to moderate loads, you should test the functionality of your brakes at regular intervals by pressing firmly on the brake pedal at high speeds. This improves the grip of the brake pads.
WARNING
Make sure that you do not endanger other road users when you apply the brakes.
You can find a description of Brake Assist (BAS) on ().
Limited braking performance on salttreated roads
WARNING The layer of salt on the brake discs and the brake pads/linings may cause a delay in the braking effect, resulting in a significantly longer braking distance, which could lead to an ...Parking brake
If you drive on wet roads or dirt-covered surfaces, road salt and/or dirt could get into the parking brake. In order to prevent corrosion and a reduction in the braking power of the parking brake ...See also:
Engine coolant
NOTE
Each quantity indicated here is only a guideline. The necessary quantity for
replacement may differ slightly depending on the
temperature and other factors.
For the checking, adding and ...
Brake Adjustment
Every time the brakes are applied, with or without the vehicle moving, the brakes
adjust for wear. ...
Installing the wheel cover
Installing the wheel cover
Align the valve with the valve hole in the
cover, then fit the cover on the wheel by
tapping your hand evenly around the
circumference of the cover. ...