Subaru Forester: Manual transmission - Starting and operating - Subaru Forester Owner's ManualSubaru Forester: Manual transmission

Manual transmission
Manual transmission

The manual transmission is a fully synchromeshed, 5-forward-speed and 1-reverse- speed transmission.

The shift pattern is shown on the shift lever knob. When shifting from 5th gear to reverse gear, first return the shift lever to the neutral position then shift into reverse gear.

To change gears, fully depress the clutch pedal, move the shift lever, and gradually let up on the clutch pedal.

If it is difficult to shift into gear, put the transmission in neutral, release the clutch pedal momentarily, and then try again.

- Do not drive the vehicle with the

- Do not drive the vehicle with the clutch disengaged (i.e., when the clutch pedal is depressed) or with the shift lever in the neutral position. Engine braking has no effect in either of these conditions and the risk of an accident is consequently increased.

- Do not engage the clutch (i.e., release the clutch pedal) suddenly when starting the vehicle.

By doing so the vehicle might unexpectedly accelerate or the transmission could malfunction.

Shift into reverse ONLY when the

Shift into reverse ONLY when the vehicle has completely stopped. It may cause damage to the transmission to try shifting into reverse when the vehicle is moving.

Changing the remote control batteries
- Do not let dust, oil or water get on or in the remote engine start transmitter when replacing the battery. - Be careful not to damage the printed circuit board in the remote engine st ...

See also:

Repair and replacement procedure
The front air bags, side air bags, curtain and rollover air bags and pretensioners are designed to activate on a one-time-only basis. As a reminder, unless it is damaged, the supplemental air ...

Parking brake
Applying the parking brake To engage the parking brake, first apply the foot brake and then without pressing the release button in, pull the parking brake lever up as far as possible. In add ...

Dialing from call histories
1 Select “All calls”, “Missed calls”, “Incoming calls” or “Outgoing calls” using . 2 Select a desired number using  and press the off-hook switch. The following operations c ...