GMC Terrain: License Plate Lamp
To replace one of these bulbs:
1. Open the liftgate partway. See Liftgate on page 2‑9.
Passenger Side Shown, Driver Side Similar
2. Push the left end of the lamp assembly toward the right.
3. Pull the lamp assembly down to remove it from the liftgate.
A. Bulb Socket
B. Bulb
C. Lamp Assembly
4. Turn the bulb socket (A) counterclockwise to remove it from the lamp assembly (C).
5. Pull the bulb (B) straight out of the bulb socket.
6. Push the replacement bulb straight into the bulb socket and turn the bulb socket clockwise to install into lamp assembly.
7. Turn the lamp assembly into the liftgate engaging the clip side first.
8. Push on the lamp side opposite the clip until the lamp assembly snaps into place.
Back–Up Lamp
Removal of the lamp assembly is not required to replace the back-up lamp bulb.
To replace one of these lamps:
1. Open the liftgate. See Liftgate on page 2‑9.
2. Remove the interior trim acces ...
Replacement Bulbs
For replacement bulbs not listed here, contact your dealer. ...
See also:
Adding Engine Oil
Unscrew and remove the engine oil
fill cap on top of the valve cover.
Pour in the oil slowly and carefully
you do not spill any. Clean up any
spills immediately. Spilled oil could
damage co ...
Instrument panel light control
The brightness of the instrument panel lights can be adjusted.
1 Brighter
2 Darker
When the headlight switch is
turned on, the brightness will
be reduced slightly unless the
control dial is tu ...
Image settings
Screen settings can be made for brightness,
contrast, tint and color.
Press on the remote control and
change
the setting under Image settings on the
screen. See also page 251 for additional ...
