Jeep Liberty: Lap/Shoulder Belt Untwisting Procedure
Use the following procedure to untwist a twisted lap/ shoulder belt.
1. Position the latch plate as close as possible to the anchor point.
2. At about 6 to 12 in (15 to 30 cm) above the latch plate, grasp and twist the belt webbing 180 degrees to create a fold that begins immediately above the latch plate.
3. Slide the latch plate upward over the folded webbing.
The folded webbing must enter the slot at the top of the latch plate.
4. Continue to slide the latch plate up until it clears the folded webbing.
Adjustable Upper Shoulder Belt Anchorage
In the front seating positions, the shoulder belt can be
adjusted upward or downward to position the belt away
from your neck. Press the release button to release the
anchorage, and then move it ...
Seat Belt Lock Out
The center rear seat belt system has a lock out feature that
will not allow you to extract the center webbing unless
the rear seat upper latch is engaged. ...
See also:
Capacity weight
All weight added to the curb weight, including
cargo and optional equipment. When towing,
trailer hitch tongue load is also part of cargo
weight.
NOTE
For trailer towing information, please re ...
Ride Control System Messages
ALL WHEEL DRIVE OFF
If your vehicle has the All-Wheel Drive (AWD) system, this message displays when
the rear drive system is overheating. This message turns off when the rear drive
system cools ...
Crash-responsive emergency lighting
The interior lighting is activated automatically if the vehicle is involved in
an accident.
To switch off the crash-responsive emergency lighting: press the hazard warning
lamp button.
or
Lock ...
