Nissan Rogue: Installing top tether strap
Installing top tether strap
First secure the child restraint with the LATCH system (rear outboard seating positions only) or the seat belt as applicable.
1. Remove the anchor cover from the anchor point which is located directly behind the child seat.
2. Position the top tether strap over the top of the seatback.
3. Secure the tether strap to the tether anchor bracket that provides the straightest installation.
4. Tighten the tether strap according to the manufacturer’s instructions to remove any slack.
If you have any questions when installing a top tether strap, consult your NISSAN dealer for details.
Forward-facing child restraint installation using the seat belts
- The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not bein ...Booster seats
Precautions on booster seats If a booster seat and seat belt are not used properly, the risk of a child being injured in a sudden stop or collision greatly increases: - Make sure the shou ...See also:
Front Fog Light Switch (if equipped)
Front Fog Light
Switch (if equipped)
The front fog light comes on when the fog light switch is pushed in with:
• the lighting switch turned to the third position and the beams set to the low
...
Voice Control System
The audio system can also be
operated by voice control. See the
navigation system manual for
complete details. ...
Under-floor storage compartment (if equipped)
Under-floor storage compartment (if equipped)
The storage compartment is located under
the floor of the cargo area, and it can be
used to store small items. To open the lid,
pull the tab up ...