Volvo XC60: Installing the cover - Cargo area cover - Cargo area - During your trip - Volvo XC60 Owner's ManualVolvo XC60: Installing the cover

1. Press the end piece on one side of the cargo area cover into the retaining bracket in the side panel of the cargo area 1.

2. Do the same on the opposite side 2.

3. Press both sides of the cover until they click into place 3. The red mark will no longer be visible.

4. Check that both ends of the cover are securely locked in place.

    Use
    • Pull the cover over the cargo and hook it into the holes in the rear cargo area pillars. • To retract (roll up) the cover, release it from the holes and guide it toward the rear seat back ...

    Removing the cover
    1. Press one of the end pieces of the cover inward. 2. Pull the cover carefully upward and outward. The other end will release automatically from its retaining bracket. ...

    See also:

    Loading tips
    - The GVW must not exceed GVWR or GAWR as specified on the F.M.V.S.S./ C.M.V.S.S. certification label. - Do not load the front and rear axle to the GAWR. Doing so will exceed the GVWR. - ...

    Windshield Wiper
    1. MIST 2. OFF 3. INT Intermittent 4. LO Low speed 5. HI High speed 6. Windshield washers Push the right lever up or down to select a position. MIST - The wipers run at high speed until ...

    Starting Procedures
    Before starting your vehicle, adjust your seat, adjust both inside and outside mirrors, and fasten your seat belts. WARNING! • When leaving the vehicle, always remove the key fob from the ign ...