Subaru Forester: Initialization of power window (type A)
If the vehicle’s battery is disconnected due to situations such as battery or fuse replacement, the following functions are deactivated.
- One-touch auto up/down function
- Anti-entrapment function
Initialize the power window using the following procedure to reactivate these functions.
1. Close the driver’s door.
2. Turn the ignition switch to the “ON” position.
3. Open the driver’s side window halfway by pushing down the power window switch.
4. Pull up the power window switch and close the window completely. Continue pulling up the switch for approximately 1 second after the window is closed completely.
Power window operation by passengers
Each passenger window can be controlled
by the power window switch located on
the door.
To open:
Push the switch down and hold it until the
window reaches the desired position.
To close:
P ...
Rear gate
The rear gate can be locked and unlocked
using any of the following systems.
- Power door locking switch: Refer to
“Power door locking switches”.
- Remote keyless entry system: Refer to
...
See also:
Engine Oil Selection
For best performance and maximum protection under all
types of operating conditions, the manufacturer recommends
engine oils that are API Certified and meet the
requirements of Chrysler Material ...
Introduction
The Dynamic Stability and Traction Control
system (DSTC) consists of a number of functions
designed help reduce wheel spin, counteract
skidding, and to generally help improve
directional stabi ...
Using the rear center seat belt
If the left-hand rear seat backrest is folded down and back up again, the rear
center seat belt may lock. The seat belt can then not be pulled out.
To release the rear center seat belt: pull out ...
