Nissan Rogue: If your vehicle is stolen - HomeLink® Universal Transceiver (if so equipped) - Instruments and controls - Nissan Rogue Owner's ManualNissan Rogue: If your vehicle is stolen

If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink®. Consult the Owner’s Manual of each device or call the manufacturer or dealer of those devices for additional information.

When your vehicle is recovered, you will need to reprogram the HomeLink® Universal Transceiver with your new transmitter information.

FCC Notice:

This device complies with FCC rules part 15. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference that may be received, including interference that may cause undesired operation.

The transmitter has been tested and complies with FCC and DOC/MDC rules.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the device.

DOC: ISTC 1763K1313

FCC I.D.: CB2V67690

    Reprogramming a single HomeLink® button
    To reprogram a HomeLink® Universal Transceiver button, complete the following. 1. Push and hold the desired HomeLink® button. Do not release the button until step 4 has been completed. 2. Wh ...

    See also:

    Sound stage
    The sound experience can be optimized for the driver's seat, both front seats or the rear seat. If the front and rear seats are occupied, the sound stage setting Front seats is recommended. Sele ...

    How to Wear Safety Belts Properly
    This section is only for people of adult size. There are special things to know about safety belts and children. And there are different rules for smaller children and infants. If a child will be r ...

    Forward-facing child restraint installation using the seat belts
    - The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not bein ...