Subaru Forester: Hill start assist system (MT models)
Ensure that the Hill start assist system
operates properly under the following
circumstances:
1. Stop the vehicle on an uphill grade by
depressing the brake pedal and clutch
pedal, with the engine running.
2. Make sure that the vehicle does not move backward even after the brake pedal is released.
3. Then make sure the vehicle starts climbing the grade by following the normal starting procedures.
If the Hill start assist system does not operate as described above, contact with your SUBARU dealer.
Checking the clutch pedal free play
1) 0.16 – 0.43 in (4.0 – 11.0 mm) Lightly press the clutch pedal down with your finger until you feel resistance, and check the free play. If the free play is not within proper specifica ...Replacement of brake pad and lining
The front disc brake and the rear disc brake have audible wear indicators on the brake pads. If the brake pads wear close to their service limit, the wear indicator makes a very audible scra ...See also:
When connecting iPod®
Each time you briefly press the “RPT”
button, the mode changes in the following
sequence.
Type C audio:
Type D audio:
NOTE
- The “ALL RPT” indication refers to
the repeat play ...
Windshield defrosting and defogging
Manual climate control system To defog inside windshield 1. Select any fan speed
except “0”. 2. Select desired temperature. 3. Select the or position. 4. The outside
(fresh) air position is ...
Turning ACC off completely
• From standby mode, press once.
• From active mode, press twice.
The set speed and time interval are then
cleared from the system's memory and cannot
be resumed by pressing . ...