Jeep Liberty: High/Low Beam Switch
Push the multifunction lever away from you to switch the headlights to high beam. Pull the multifunction lever toward you, to switch the headlights back to low beam.
Turn Signals
Move the multifunction lever up or down and the arrows on each side of the instrument cluster flash to show proper operation of the front and rear turn signal lights. Turn Signal Control NOTE: ...Flash-To-Pass
You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released. NOTE: If the m ...See also:
Extending Engine Run Time
For a 10-minute extension, repeat Steps 1 and 2 while the engine is still running.
The remote start can be extended once.
When the remote start is extended, the second 10 minutes will start immedia ...
Obstacle Detection Features
If the liftgate encounters an obstacle during a power open or close cycle, a
warning chime will sound and the liftgate will automatically reverse direction to
the full closed or open position. Aft ...
Voice Control Tips
Air or wind noise fromthe
dashboard and side vents and all
windows may interfere with the
microphone. Adjust or close them
as necessary.
Press and release the HFL Talk
button each time yo ...