Hyundai Tucson: Hazard warning system
The hazard warning system should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as possible. The hazard warning lights are turned on by pushing in the hazard switch. This causes all turn signal lights to blink. The hazard warning lights will operate even though the key is not in the ignition. To turn the hazard warning lights off, push the switch a second time.
Front fog light switch
(If installed)
To turn on the front fog lights, push the switch.
They will light when the headlight switch is in the
second position and the ignition key is in the
"ON" position.
N ...
Window defroster switch
Windshield wiper Blade De-icer
(If installed)
The windshield wiper blade de-icer is turned on
by pushing in the switch. To turn the de-icer off,
push the switch a second time. The windshield ...
See also:
Parking brake warning
The light illuminates with the parking
brake applied while the ignition switch is
in the “ON” position. It turns off when the
parking brake is fully released. ...
Electrical Power Outlet
Your vehicle is equipped with a fused 12 Volt (13 Amp)
power outlet. This power outlet is located on the instrument
panel, below the climate controls. It has power
available when the ignition sw ...
Remote Keyless Entry (RKE) System Operation
The Remote Keyless Entry (RKE) transmitter will work up to 60m (195 ft) away
from the vehicle.
There are other conditions which can affect the performance of the transmitter.
See Remote Keyless E ...
